Fuel and Air Systems/Remove and Install Carburetor DISASSEMBLE, CLEAN, INSPECT AND ASSEMBLE CARBURETOR NOTE: FC400V, FC420V and FC540V engines are equipped with a fuel control solenoid. 2. Spray all passages with a carburetor cleaning spray to verify that all internal passages are open. FC540V engines with engine tag number BS00, pilot jet is pressed in. IMPORTANT: Rinse carburetor body in warm water to neutralize corrosive action of cleaner on aluminum. IMPORTANT: To remove float, use a long nosed pliers on end of pin. Do not strike opposite end of pin. Damage to pin holder may result. 3. Rinse carburetor with warm water and dry with compressed air. Do not use rags or paper to dry parts:
lint may plug holes or passages. Do not clean holes or passages with small drill bits or wire. 4. Inspect all parts for wear or damage, replace as necessary. 1. Soak carburetor body and all parts, except gaskets, float and plastic rings, in carburetor cleaning solvent for 1/2 hour maximum. NOTE: Main jet high altitude kits are available. Float is plastic. The float cannot be adjusted. Replace if necessary. Use this procedure when referring to the following three exploded views. MX,4005A1,A12 -19-21OCT92 40 05 5 CTM5 (20OCT92) 40-05-5 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=292