John Deere K Series Air-Cooled Engines — DISASSEMBLE, CLEAN, INSPECT AND ASSEMBLE CARBURETOR

Fuel and Air Systems/Carburetor CTM5 (20OCT92) 45-05-4 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=369 DISASSEMBLE, CLEAN, INSPECT AND ASSEMBLE CARBURETOR IMPORTANT: To remove float, use a long nosed pliers on end of pin. Do not strike opposite end of pin. Damage to pin holder may result. Do not clean holes or passages with small drill bits or wire. 1. Soak carburetor body and all parts, except gaskets, float and plastic rings, in carburetor cleaning solvent for 1/2 hour maximum. 2. Spray all passages with a carburetor cleaning spray to verify that all internal passages are open. IMPORTANT:

Rinse carburetor body in warm water to neutralize corrosive action of cleaner on aluminum. 3. Rinse carburetor with warm water and dry with compressed air. Do not use rags or paper to dry parts: lint may plug holes or passages. 4. Inspect all parts for wear or damage, replace as necessary. NOTE: Float is plastic. The float cannot be adjusted. Replace if necessary. FE290D: Main jet high altitude kits and main air jet kits for standard or heavy duty air cleaners are available through the parts catalog. FE290R: Main jet high altitude kits are available through the parts catalog. MX,4505A1,A3 -19-21OCT92 45 05 4