John Deere K Series Air-Cooled Engines — MEASURE CRANKSHAFT END PLAY

Cylinder Block, Valves and Internal Components/Crankshaft INSPECT CRANKSHAFT BALL BEARING 1. Remove flywheel end oil seal. (See Inspect Oil Seals in this group.) 2. Remove crankshaft bearing using a bearing, bushing and seal driver set. M38073 -UN-29AUG88 3. Thoroughly clean bearing in solvent. Dip bearing in light weight oil. 4. Spin the bearing by hand and check for axial (A) and radial (B) free play. 5. Replace the bearing if it is noisy or has too much play. 6. Install bearing flush to inside of crankcase using a bearing, bushing and seal driver set. 7. Install oil seal.

MX,5020A1,A33 -19-21OCT92 CHECK CRANKSHAFT ALIGNMENT (TIR) Place crankshaft into an alignment jig and rotate crankshaft slowly. Use dial indicators (A) to measure maximum total indicated runout (TIR). If not according to specification replace crankshaft. M51761 -UN-07SEP88 SPECIFICATIONS Maximum TIR . . . . . . . . . . . . . . . . . . . . . . . . . 0.05 mm (0.002 in.) MX,5020A1,A34 -19-21OCT92 CTM5 (20OCT92) 50-20-20 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=451 MEASURE CRANKSHAFT END PLAY 1. Measure end play using dial indicator (A). Record this measurement. 2. Move crankshaft in and out. Remove crankcase cover -UN-06SEP88 and adjust end play if not within specifications.

(See this group.) SPECIFICATIONS M30048 End Play . . . . . . . . . . . . . . . . . . 0.09—0.22 mm (0.004—0.009 in.) MX,5020A1,A35 -19-21OCT92 50 20 20