John Deere K Series Air-Cooled Engines — DISASSEMBLE AND ASSEMBLE OIL PUMP

Cylinder Block, Valves and Internal Components/Oil Pump 8. Hone the cylinder an additional 0.028—0.030 mm (0.0011—0.0012 in.) for final bore specifications. This allows for 0.020 mm (0.0008 in.) shrinkage when cylinder cools. IMPORTANT: DO NOT use gasoline or commercial solvents to clean cylinder bores. Solvents will not remove metal particles produced during honing. 9. Clean the cylinder thoroughly using soap, warm water and clean rags. Continue to clean cylinder until white rags show no discoloration. 10. Dry the cylinder. Apply engine oil to cylinder wall.

M98,2040A,A9 -19-21OCT92 CTM5 (20OCT92) 50-20-26 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=457 DISASSEMBLE AND ASSEMBLE OIL PUMP 1. Remove crankcase cover. (See this group.) 2. Remove oil pump assembly (A). -UN-19FEB91 3. Remove relief spring and ball (B). 4. Inspect all parts. (See this group.) 5. Install oil pump assembly. Tighten pump cover cap M54791 screws to specifications. 6. Install relief spring and ball. 7. Install crankcase cover. TORQUE SPECIFICATIONS Pump Cover Cap Screws . . . . . . . . . . 17—23 N·m (150—204 lb-in.) MX,5020A1,A43 -19-21OCT92 50 20 26