Cylinder Block, Valves and Internal Components/Inspect and Replace INSPECT AND REPLACE GOVERNOR IMPORTANT: Removal damages governor. If not damaged, do not remove. 1. Remove crankcase cover. (See this group.) M51762 -UN-07SEP88 2. Inspect governor. If necessary to replace, remove with screwdriver. 3. If removed, press shaft (C) back into block until it protrudes 32.2—32.8 mm (1.267—1.291 in.). NOTE: Assemble sleeve and gear before installing assembly on shaft. 4. Install sleeve (A) onto governor gear (B). 5. Install governor assembly onto shaft. Push down on assembly until it snaps into place.
MX,5020A1,A51 -19-21OCT92 CTM5 (20OCT92) 50-20-29 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=460 INSPECT AND REPLACE GOVERNOR SHAFT NOTE: It is not necessary to remove governor shaft unless damaged. -UN-19FEB91 1. Remove crankcase cover. (See this group.) 2. Inspect shaft (A). Replace if damaged. 3. To replace shaft, loosen nut (E) on lever (C). M54797 4. Remove retaining pin (D), governor shaft and washer (B). A—Governor Shaft 5. Install washer, shaft and retaining pin. Tighten nut to B—Washer 7 N·m (62 lb-in.). C—Governor Lever D—Retaining Pin E—Nut MX,5020A1,A52 -19-21OCT92 50 20 29