John Deere K Series Air-Cooled Engines — DISASSEMBLE, CLEAN, INSPECT AND ASSEMBLE CARBURETOR—FA210D-AS19-01/AS17/BS17/CS17

Fuel and Air Systems—FA210D/Disassemble, Clean, Inspect and Assemble Carburetor IMPORTANT: To remove float, use a long nosed pliers on end of pin. Do not strike opposite end of pin. Damage to pin holder may result. IMPORTANT: Rinse carburetor body in warm water to neutralize corrosive action of cleaner on aluminum. 3. Rinse carburetor with warm water and dry with compressed air. Do not use rags or papers to dry parts: lint may plug holes or passages. Do not clean holes or passages with small drill bits or wire. 1. Soak carburetor body and all parts, except gaskets and plastic rings, in carburetor cleaning solvent for 1/2 hour maximum. 4.

Inspect all parts for wear or damage, replace as necessary. 20 06 9 NOTE: Main jet high altitude kits are available for FA210D-AS17, BS17 and CS17 engines only. 2. Spray all passages with a carburetor cleaning spray to verify that all internal passages are open. MX,2006A1,A10 -19-21OCT92 IMPORTANT: Do not push on float or inlet needle valve when adjusting float level. 5. Adjust float level. With carburetor upside down, float surface must be parallel (A) to carburetor body. Bend tang (B) to adjust float surface angle. M80283 -UN-11MAR91 MX,2006A1,A11 -19-21OCT92 CTM5 (20OCT92) 20-06-9 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=50