Cylinder Block, Valves and Internal Components/Remove and Install Valves and Springs CTM5 (20OCT92) 20-20-2 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=63 REMOVE AND INSTALL VALVES AND SPRINGS 1. Remove carburetor. (See Group 05.) 2. Remove cylinder head. (See Group 15.) -UN-11MAR91 3. Remove tappet chamber cover/breather and gasket. 4. Compress valve spring (B) with a spring compressor (A) and move spring retainer (C) so larger hole is around M80246 valve stem. 5. Remove compressor, valves, springs and retainers. A—Spring Compressor 6. Inspect and analyze valves. (See Section 100, Group B—Valve Spring 05.) C—Spring Retainer D—Drainback Hole 7.
Inspect springs, valve guides and seats. (See this group.) 8. Check valve-to-tappet clearance. (See this group.) 9. Check that drainback hole (D) is open. 10. Align valve springs, and retainers in tappet chamber. 11. Coat valve stems with oil and install in cylinder block. 12. Compress each spring and position retainer so smaller hole is around valve stem. 13. Install tappet chamber cover/breather and new gasket. 14. Install cylinder head. 15. Install carburetor. MX,2020A1,A3 -19-21OCT92 20 20 2