Cylinder Block, Valves and Internal Components/Inspect Piston 8. Measure piston pin outer diameter. Replace if less than specification. 9. Measure piston pin bore. Replace piston if measurement is greater than specification. SPECIFICATIONS M50064 -UN-31AUG88 M80258 -UN-11MAR91 Piston Pin O.D. Piston Bore I.D. (MIN) (MAX) FA130D 12.98 mm 13.04 mm (0.511 in.) (0.513 in.) FA210D 14.98 mm 15.05 mm (0.590 in.) (0.593 in.) CTM5 (20OCT92) 20-20-12 K Series Air Cooled Engine MX,2020A1,A20 -19-21OCT92 AllTractorManuals.com 220596 PN=73 6. Inspect piston for scoring or fractures. Replace piston if damaged. NOTE: On FA130D engines, compression rings are tapered and cannot be measured as shown.
-UN-29AUG88 Inspect clearance visually. Replace piston if clearance appears excessive. 7. Check ring grooves for wear at several points around piston. Replace piston if clearance is greater than M38102 specification. CLEARANCE SPECIFICATION (MAX) Top Ring Second Ring Oil Control Ring FA130D — — 0.15 (0.006 in.) FA210D 0.15 mm 0.13 mm 0.12 mm (0.006 in.) (0.005 in.) (0.004 in.) MX,2020A1,A19 -19-21OCT92 20 20 12