John Deere K Series Air-Cooled Engines — ADJUST ARMATURE AIR GAP

Group 25 Ignition and Charging System ADJUST ARMATURE AIR GAP 1. Turn flywheel magnet away from armature. 2. Insert feeler gauge blade (B), between flywheel and armature. M80271 -UN-11MAR91 M80298 -UN-11MAR91 3. Push armature against flywheel and tighten screws (A). 4. Turn flywheel to remove gauge. AIR GAP SPECIFICATIONS FA130D and FA210D-AS20 Feeler Gauge Blade FA130D . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.50 mm (0.019 in.) FA210D . . . . . . . . . . . . . . . . . . . . . . . . . . .

0.30 mm (0.012 in.) FA210D-AS19-01/AS17/BS17/CS17 CTM5 (20OCT92) 20-25-1 K Series Air Cooled Engine MX,2025A1,A2 -19-21OCT92 AllTractorManuals.com 220596 PN=86 REMOVE AND INSTALL ARMATURE WITH COIL 1. Remove blower housing. (See Group 10.) 2. Disconnect wiring lead (C). -UN-11MAR91 3. Remove cap screws (A) and armature with coil (B). 4. Loosely install armature with coil. M80270 5. Connect wiring lead. FA130D and FA210D-AS20 6. Adjust armature air gap. (See this group.) 7. Install blower housing. -UN-11MAR91 M80297 FA210D-AS19-01/AS17/BS17/CS17 MX,2025A1,A1 -19-21OCT92 20 25 1