Deutz — Removing and installing the crankshaft

Crankshaft TCD 2013 2V W 05-05-01 Removing the big end bearing cap ●Insert turn-over gear (1). ●Tighten screws (2). 1 2 6 © 44222-0 ●Place lifting journal of the respective cylinder at bot - tom dead centre (BDC). Attention! Do not jam the con rods when turning the crankshaft. © 44223-0 ●Unscrew screws (1). ●Remove big end bearing cap (2). ●Remove bearing shell. Lay out components in the order in which they should be installed. 2 Note order of cylinders. 1 © 44224-0 © 02/2010 OBJ_DOKU-21758-001.fm 2/12