High-pressure pump TCD 2013 2V W 17-01-01 Technical Data Tightening specifications 6 For the tightening procedure according to torque using a torque wrench, a maximum variation of the tightening torque of +/- 10% is permissible. © 02/2010 OBJ_DOKU-21786-001.fm 7/8 D no. Name Screw type Notes / Remark Value A07 003 Injection pipe on rail and injector, High pressure pipe on high pressure pump and rail Union nut Stage 1: Observe assembly specification. Use new pipe. 10 Nm A07 003 Injection pipe on rail and injector, High pressure pipe on high pressure pump and rail Union nut Stage 2: 60° +15° A07 031 High pressure pump to crankcase M10x30-10.9 Stage 1:
Screws oiled 10 Nm A07 031 High pressure pump to crankcase M10x30-10.9 Stage 2: 50 Nm A07 032 Control block to crankcase M8x75 M8x85 Observe tightening sequence. 20 Nm A12 092 Pipe union, pipe diameter 8 mm, ring piece Hollow screw M12x1.5 29 Nm A12 093 Pipe union, pipe diameter 10 mm, ring piece Hollow screw M14x1.5 39 Nm A12 094 Pipe union, pipe diameter 12 mm, ring piece Hollow screw M16x1.5 49 Nm A12 095 Pipe clips, fastening M8 20 Nm