Deutz — Removing and installing the fuel supply pump (V-belt drive)

Fuel pump TCD 2013 2V W 20-02-01 Removing and installing the fuel supply pump (V-belt drive) Standard tools: Hose clip pliers 8011 V-belt tension measuring device 8115 User notes Operation manual Danger! Special tools: Plugs/caps 170160 Wait 30 seconds after switching off the engine before working on the fuel system. Attention! Ensure utmost cleanliness when working on the fuel system. Carefully clean the area around the affected parts. Blow damp areas dry with compressed air. Observe the safety regulations and natio - nal specifications for handling fuels. Close all connections immediately after opening with new, clean plugs/caps.

Do not remove plugs/caps until immedia - tely before assembling. Collect leaking operating fluids in suitable vessels and dispose of according to regu - lations. After all work on the fuel system, it must be bleeded - see the operation manual, chap - ter "6 Fuel system“. Only test / tighten / renew V-belts with the engine at a standstill. 6 The V-belt tension of new V-belts must be checked after they have been running for 15 minutes. Removing the fuel supply pump Danger! Wait 30 seconds after switching off the engine before working on the fuel system. ●Loosen screws (1). Do not unscrew screws. 1 © 44037-1 © 02/2010 OBJ_DOKU-21791-001.fm 1/6