Deutz — 5.1 Sorted alphabetically

Job card overview TCD 2013 2V Sorted alphabetically 5 © 02/2010 OBJ_DOKU-21742-001.fm 3/12 Activity Job card Maintenance group Assembling/disassembling shaft sleeve on the crankshaft (opposite side to flywheel) W 01-02-02 Front cover Check alignment of connection housing W 52-01-02 Connection housing Checking collar contact for cylinder liner W 01-13-01 Crankcase Checking piston overhang W 08-03-02 Cylinder head Checking the axial clearance of the crankshaft W 05-05-03 Crankshaft Checking the camshaft W 10-02-02 Camshaft Checking the compression pressure W 08-00-01 Cylinder head Checking the con rod W 06-01-02 Connecting rod Checking the crankshaft W 05-05-02 Crankshaft Checking the overhang of the cylinder liner W 01-05-01 Crankcase Checking the piston W 07-01-02 Piston Checking the piston rings and piston ring grooves W 07-02-02 Piston Checking the thermostat (in the removed state) W 38-01-02 Thermostat housing Checking the valve guide W 08-04-03 Cylinder head Checking the valve lag W 08-04-04 Cylinder head Checking the valves W 08-04-02 Cylinder head Disassembling, assembling and checking the rocker arm and rocker arm bracket W 11-02-02 Control parts Dismantling and assembling the fan drive W 39-02-03 Fan drive Installing and removing turning gear W 49-02-01 Tools Installing and removing turning gear (Torsional vib- ration damper) W 49-02-02 Tools Mounting engine on assembly block and demoun- ting W 46-00-01 Engine mounting Removing and install the charge air line W 22-01-01 Charge air line Removing and install the heating flange W 63-01-01 Start aid Removing and installing cylinder head W 08-03-01 Cylinder head Removing and installing temperature transmitter (coolant) W 48-05-01 Electrical equipment Removing and installing the belt tensioner (V-rib belt) W 39-01-01 Fan drive Removing and installing the cable harness W 48-01-01 Cable harness Removing and installing the camshaft W 10-02-01 Camshaft Removing and installing the connection housing W 52-01-01 Connection housing Removing and installing the control block W 17-01-01 High-pressure pump