Cylinder liner TCD 2013 2V W 04-01-02 Testing the cylinder liner Standard tools: Micrometer gauge Internal measuring device W 04-01-01 W 06-01-01 W 08-03-01 Special tools: Dial gauge 100400 The crankshaft bearing covers must be mounted properly for measuring the cylinders. 6 Testing the cylinder liner ●Remove cylinder head. W 08-03-01 ●Check cylinder liner for visible signs of wear. ●Remove piston and connecting rod. W 06-01-01 © 44074-0 ●Prepare internal measuring device: Mount probe bolt for the appropriate measuring range in the internal measuring device. Mount dial gauge with approx. 1 mm pre-tension in the internal measuring device. Set micrometer gauge to 108 mm.
Balance the internal measuring device between the test surfaces of the micrometer gauge and set the dial gauge at the reversal point of the pointer to "0". © 36094-1 © 02/2010 OBJ_DOKU-21754-001.fm 1/4