SAFETY Notes on Aftertreatment Device About Aftertreatment Device The aftertreatment device removes particulate matter (PM) and NOx (Nitrogen Oxide) from the exhaust gas. Follow the instructions below to prevent the aftertreatment device from being damaged. d WARNING: Exhaust gas from the aftertreatment device, muffler, exhaust piping and tail piping becomes hot during and right after engine running and regeneration of aftertreatment device. Keep away from the exhaust system or hot gas from the exhaust piping during regeneration. Be careful to avoid skin contact with exhaust gas. It may cause severe burns. White smoke may be generated during aftertreatment device regeneration.
Do not attempt to perform aftertreatment device manual regeneration in a badly ventilated area. Ammonia odor may occur during aftertreatment device regeneration temporarily, but is not a trouble. Do not touch water coming directly out of the aftertreatment device. The water is mildly-acidic by oxidation catalyst mounted in the aftertreatment device. If filter water spills on your skin, immediately flush it out with clean water. Precautions for Communication Terminal Electrical wave transmitted from the communication terminal may cause malfunction of other electronic devices.
Inquire to the device manufacturer for information on electrical wave disturbance when using an electronic device near the communication terminal. Never attempt to disassemble, repair, modify or displace the communication terminal, antennas or cables. Failure to do so may result in damage and/or fire to the base machine or to the communication terminal. (When required to remove or install the communication terminal, consult your authorized dealer.) Do not pinch or forcibly pull cables, cords or connectors. Failure to do so may cause a short or broken circuit that may result in damage and/or fire to the base machine or to the communication terminal. S-36