Section 8 Electrical TELLTALE SYMBOLS Kenworth’s interior allows Body Builders to customize the dash telltale symbols (warning lights). The editable telltale symbols are located on removable cards inside the baseline cluster. This section will describe how to replace and insert editable cards, as well as how to activate the telltale lights. Note the numbers 1 – 16 on Figure 8-10. These are how the positions are identified in table 8-1 and on the instrument panel harness breakouts for the “editable” telltales behind the right hand cluster. To remove the editable cards follow steps 1-3 in the instructions for accessing gauges and switches (page 8-9).
Remove the rubber access cover on the side of the cluster by pulling by hand. The access cards have a positive lock. To remove the card pry upwards on the lock with a small screwdriver and pull the card out with pliers. See Figure 8-10 below that details the cards. To reinstall a card slide it in either by hand or with pliers. New cards will come with the installation tab (as shown in the figure). After installing the card simply break off the tab by bending. FIGURE 8-10. Telltale Symbol Standard Cards 8-17 08/12