Section 4 Exhaust & Aftertreatment Minimum 12” Line Length Below Dosing Module Figure 4-9: Routing DEF Lines and DEF Trap Clear Back of Cab Supply Module The CBOC Supply Module (or Pump) standard mounting location is inside of the frame rail back of cab. Body builders may need to relocate this component, and should follow the location and length restrictions above. Additionally the mounting and the orientation of the Supply Module must not exceed 45° (from vertical) in two directions as shown in Figure 4-10 below. Figure 4-10: Supply Module Allowed Clocking Angles 08/12 4-9