Komatsu — NOTES REGARDING LUBRICATION

NOTES REGARDING THE ELECTRICAL SYSTEM MAINTENANCE If the cables are wet or their insulating material is damaged, the electrical system may short, and may result in machine malfunctions. The maintenance operations required for the electrical system are the following: 1.Check the alternator belt tension. 2.Check the alternator belt for damage or breakage. 3.Check the battery electrolyte level. Do not remove or eliminate any electrical component installed on the machine and do not install any electrical component with characteristics different from those specified and approved by Komatsu. Be careful to keep the electric system dry.

When working on seashores or river or lake banks, protect the jack plugs from corrosion. Do not connect any optional device to the fuses, ignition switch, battery, relays, etc. For the installation of any optional equipment, contact your Komatsu Dealer. If any electric welding needs to be done, disconnect the battery and the alternator. NOTES REGARDING LUBRICATION Lubrication makes the operations carried out with the machine and work equipment smoother, while preventing wear and the noise that may be produced if the articulations are dry. Lubrication is to be carried out with grease or oil. The maintenance operations required for the components that need lubricating are the following: 1.

Check the fluid and lubricant levels. 2. Change oil at recommended intervals. 3. Inject grease through the grease fittings. Use only the specified lubricants, according to the ambient temperature. Always clean the grease fittings before injecting grease and remove any excess grease after lubrication; this cleaning operation must be performed with extreme care on the revolving parts. Keep the lubricants at the correct levels; excessive or insufficient quantities are to be avoided. WB140-2N, WB150-2N 3-5