Komatsu — PERIODIC REPLACEMENT OF COMPONENTS CONNECTED WITH SAFETY

MAINTENANCE PERIODIC REPLACEMENT OF COMPONENTS CONNECTED WITH SAFETY To ensure safety at any moment while driving and using the machine, the operator must carry out all periodic maintenance operations prescribed. Furthermore, the operator must periodically replace the components indicated in the table on the follow- ing pages, which are especially related to safety and fire prevention rules. These components are subject to wear and since it is particularly difficult to evaluate their conditions through simple periodic maintenance, after a certain period it is advisable to change them independently of their state, in order to keep them efficient over time.

Repair or replace these components imme- diately in case of failures or abnormalities, even if the time interval prescribed for their change (replacement) has not elapsed yet. If the hose clamps show signs of deterioration, like deformations or cracks, replace them at the same time as the hoses. In addition to periodic replacement of the components listed on the following pages, the inspections described below are to be performed on the hydraulic hoses. In case of abnormalities, perform the necessary adjustments and replacements, or institute any other required measure.

3-16 WB140-2N, WB150-2N TYPE OF CHECK CHECK ITEM Check before starting Leakage from joints, grease fittings, hydraulic hoses, or fuel lines. Periodic check (monthly check) Leakage from joints, fittings, hydraulic hoses, or fuel lines. Damaged hydraulic or fuel lines (cracks, wear and tear). Periodic check (annual check) Leakage from joints, fittings, hydraulic hoses/fuel lines. Deteriorated, twisted, damaged hydraulic hoses/fuel lines (cracks, wear and tear) or in contact with other parts of the machine.