Komatsu — CHECKING TIRE PRESSURE

MAINTENANCE LUBRICATING FRONT AXLE JOINTS CEN- TRAL COUPLING Lubrication points (1) of the wheel joints are indicated in the photo and it is important to remember that they are located in symmetrical posi- tions, while the central joint is lubricated by means of a grease fitting (2) positioned on the frame. Lubrication must be done after carefully cleaning the grease fittings, by attaching the grease pump and using the prescribed grease. (See “FUEL, COOLANT, AND LUBRICANTS” on page 3-7). Once lubrication has been done, remove the contaminated grease that may have spread out of the joints and central coupling.

CHECKING TIRE PRESSURE Inflate the tires only after positioning them in a protec- tion cage. To inflate the tire, stand beside the external belt. Do not exceed the pressures prescribed in the “SPECIFI- CATIONS section 4". This check is indispensable to preserve the tires, keep them efficient over time and make them last longer. The correct pressures are indicated in the specifications section 4. (See “TIRES” on page 4-3.). While checking the pressure, check conditions of the tread and sidewalls 3-34 WB140-2N, WB150-2N