MAINTENANCE EVERY 500 HOURS OF OPERATION MAINTENANCE Perform these operations together with those initiated every 50 HOURS and 250 HOURS. CHANGING ENGINE OIL Change the oil with machine parked on level ground and raised loader arm with the safety lock engaged. After machine has been operated, the engine oil is very hot and may cause burns; let the engine cool down until it reaches a temperature of 40-45 ° C (104-113 ° F) before draining the oil. Oil that may be spilled during the change makes the ground slippery, therefore, use anti-slip shoes and immediately remove any trace of oil from the floor.
Oils, filters, coolant, and the battery are considered special waste and must be collected and disposed of according to anti-pollution regulations in force. When changing engine oil, also change the filter,(See “CHANGING ENGINE OIL FILTER” on page 3-42). Proceed as follows: 1. Open the engine hood. 2. Remove the oil pan drain plug (1). Collect used oil in a container of sufficient capacity. (Use a 19 mm wrench). 3. While the oil flows out, remove filler cap (2), so that oil can flow freely. 4. Change the engine oil filter. WB140-2N, WB150-2N 3-41