MAINTENANCE # Hydraulic oil in the machines equipped with demolition hammers deteriorates more rapidly than the oil of machines used for simple digging operations. On new machines, replace filter after the first 100-150 hours of operation and for successive replacements, follow the schedule on replacement interval table. # If the machine contains synthetic biodegradable oil type HEES, the filter must be replaced after the first 50 hours of operation. CHANGING FUEL FILTER Replace the filter element after work, when engine has cooled down to 40-45 ° C (104-113 ° F).
When these operations are carried out, fuel may be spilled; clean the dirty areas immediately, in order to pre- vent any risk of slipping or fire. Oils, filters, coolant, and the battery are considered spe- cial waste and must be collected and disposed of according to all anti-pollution regulations in force. The fuel filter and fuel pump can be reached after opening the engine hood. FUEL FILTER 1. Clean external surfaces of the unit and then unscrew and remove old filter ( 1 ) with the special wrench provided. 2. Clean inside of head ( 2 ). 3. Lubricate the gasket of new filter and tighten thoroughly. 4. Give it another half turn by hand. 5. Bleed the fuel supply circuit.
BLEEDING THE CIRCUIT After filling the tank, proceed as follows: 1. Turn ignition switch to “ON” position. 2. Loosen drain screw ( 3 ) of filter head ( 2 ), using a 12 mm wrench. 3-44 WB140-2N, WB150-2N