Komatsu — CHANGE REAR AXLE OIL

MAINTENANCE CHANGING THE REAR AXLE OIL Oils, filters, coolant, and the battery are considered spe- cial waste and must be collected and disposed of according to all anti-pollution regulations in force. Perform this operation with the machine positioned on level ground and at operating temperature, so that the oil becomes fluid and can be easily drained, which facilitates elimination of any suspended solid particles. DIFFERENTIAL 1. Remove drain plug (2) and let the used oil flow out completely, col- lect it in a container with suitable capacity. While the oil flows out, remove plug (1), using a 1/2” square wrench. 2.

Once the oil has been drained, reinstall plug (2) and pour oil of the prescribed type through hole (1), until level corresponding to lower edge of the hole itself is reached. # With this operation both axle shafts are filled with oil; before checking level definitively and putting back the plug, wait a few minutes, in order to permit the uniform distribution of oil. 3. Install plug (1). PLANETARY 1. Move the machine until drain plug (3) is in low position on the ver- tical axis. 2. Remove plug (3) and let used oil flow out, collect it into a container with suitable capacity, using a 1/2” square wrench. 3.

After draining oil, move the machine until plug (3) that serves also as level indicator is positioned on the horizontal axis. 4. Pour oil of prescribed type through the hole until it reaches lower edge of the hole itself. 5. Reinstall plug (3). Move the machine both forward and backward and then stop it. Check the levels again. Always use oil of the prescribed type. (See “FUEL, COOLANT, AND LUBRICANTS” on page 3-7). 3-48 WB140-2N, WB150-2N