FLUSHING COOLING SYSTEM MAINTENANCE Be extremely careful when performing this maintenance operation. Since the engine must be running, one opera- tor must remain on the machine and another operator helping after they decide on words and signals to use. After work, when the machine is stopped, the coolant is very hot and under pressure and may cause serious burns. Let the engine cool down until it reaches approxi- mately 40-45°C (104-113°F) before starting the flushing operations. Slowly loosen the radiator cap, to release residual pres- sure. Engage all work equipment safety locks. Apply parking brake and do not move the gearshift lever.
Oils, filters, coolant, and the battery are considered spe- cial waste and must be collected and disposed of according to all anti-pollution regulations in force. Whenever changing from water to using antifreeze fluids, and vice versa, it is necessary to flush the system in order to eliminate either oxide deposits or limestone encrustations. Proceed as follows: 1. Open the engine hood. 2. With the fluid still warm, open radiator drain cock (2) (see fig. A), loosen drain valve (3) positioned on the filter carrier head and loosen radiator cap (1), using a 12 mm wrench. 3. Let all the fluid flow out. Tighten valve (3) on the filter carrier head engine and close radiator drain cock (2) (see fig.
B). 4. Pour a high-quality scale remover into the radiator, in doses recom- mended on the package (remember that the capacity of the cooling system is approximately 14 liters (3.7 US gal). Fill the radiator with water. 5. Start engine and let it run at high rpm for about 15 minutes. 6. Reduce the rotation speed to idling and drain the scale removing solution through radiator drain cock (2) (see Fig. A). At the same time, fill radiator with running water for at least 40 minutes. 7. Stop engine, let all the water flow out, close radiator drain cock (2) (see fig. B), and fill the system with coolant. 8.
Start engine and after a few minutes check the fluid level in the radiator, if necessary, add more coolant before tightening cap (1). WB140-2N, WB150-2N 3-59