Komatsu — ADJUSTING AUTOMATIC RETURN OF FRONT BUCKET TO THE DIGGING POSITION

MAINTENANCE CHECKING AND ADJUSTING BRAKE PEDAL STROKE Perform this check when working on adjusting the brake pedal stroke to eliminate or prevent any problems. To check and adjust the brake pedal stroke, proceed as follows: 1. Insert connection pin (1) in order to couple the pedals. 2. By adjusting the end-of-stroke rubber pads (2), position the pedals in correspondence with measure “A”= 325 mm (12.8 in); secure the pads in this position. (Use a 13 mm wrench). 3. Lower the pedals to measure “A” 306 mm (12 in); adjust position of microswitches (3) by bringing them near the pedals and lock them. (Use a 17 mm wrench). 4.

Again, lower the pedals to measure 294 mm (11.6 in) at “A” and adjust brake pump rods (4) until they touch the pumping pistons, lock them in this position. (Use a 22 mm wrench). ADJUSTING AUTOMATIC RETURN OF FRONT BUCKET TO THE DIGGING POSI- TION The device for automatic return of front bucket to the digging position automatically brings the front bucket to loading position when it is low- ered to the ground.

The sensor is positioned on right dumping cylinder and determines the horizontal position of the bucket in relation to the ground after bucket dumping control has reached end of stroke and elec- tromagnet of the distributor rod has been operated (See “FRONT END LOADER CONTROLS” on page 2-16). The sensor must be positioned at a distance of 2-4 mm (0.078-0.157 in) from the sliding rod. 3-64 WB140-2N, WB150-2N