OPTIONAL ATTACHMENTS PALLET FORKS KIT The optional pallet forks are usually installed on the multipurpose bucket for handling pallets of materials, loading and unloading various pipe.The distance between the forks (1) can be adjusted by sliding them on the bar (2). To adjust the forks (1): Raise the bucket high enough to clear the- ground. Tip the bucket forward far enough to clear the bucket teeth. Re-position the forks to the desired distance Tip the bucket back being sure the forks do not rest on the tips of the bucket teeth. Remark When using the forks be sure the forks are fully engaged into the load. Never carry a load on the tips of the forks.
Always be aware of the extra length your forks will add when maneu- vering the machine. When traveling with the machine or when not using the forks be sure they are locked in the holding place (5) with the pins (3) and the pins are secured with the four lock pins (4). REMOVING AND INSTALLING THE FORKS To remove or install the pallet forks kit, proceed as follows: Rest the bucket in a horizontal position on a flat and level surface. Remove safety pins (6) and (7). Supports (B) must also be removed. Remove the fasteners (9) that hold the bar (2) in place. Hold one of the supports (8) and withdraw the slide bar (2), repeat the same operation for the support. 5-8 WB140-2N, WB150-2N