Komatsu — OPERATING THE CLAMSHELL BUCKET

INSTALLATION AND REMOVAL OF THE CLAMSHELL BUCKET OPTIONAL ATTACHMENTS INSTALLATION To install the clamshell bucket the aid of another person will bere- quired. To perform installation procedures, proceed as follows: 1. All work must be carried out on a flat smooth surface. 2. Neutralize all hydraulic controls and remove the standard dig- ging bucket. See “CHANGING THE BACKHOE BUCKET” on page 2-41. 3. Retract the digging bucket cylinder ram completely. 4. Install the clamshell bucket to the arm. 5. Stop the machine and neutralize all the hydraulic controls. 6. Lock the bucket ram in place at the end of its stroke. 7.

In figure (A) disconnect the supply lines (2) and (3) that oper- ate the bucket cylinder (1). Seal the couplings (4). 8. In figure (B) disconnect the supply lines (2) and (3) that oper- OPERATING THE CLAMSHELL BUCKET Consult the specific operators manual for the clamshell bucket. WB140-2N, WB150-2N 5-19 ate the bucket cylinder (1). Seal the couplings (4). 9. Connect the supply lines from the standard bucket cylinder to the lines controlling the clamshell bucket. 10. Be sure all unused lines are capped and sealed. be careful when installing lines. be sure dirt or debris does not get trapped in these couplings. 11. Start the machine and raise the clamshell off the ground. 12.

Open close and swing the bucket several times. REMOVAL To remove the clamshell bucket follow in the reverse order. When removing or installing the clamshell bucket, always wear eye and hand protection.