SAFETY PRECAUTIONS BEFORE STARTING WORK OPERATIONS Before starting your work operations it is important to perform several procedures to be sure your equipment is in a safe oper- ating condition. It is also important to be aware of the hazards involved when operating your machine. PRE-OPERATIONAL CHECKS Before starting your machine and preceding with any work operations it is important to be sure your machine is safe to oper- ate. Below is a list of some basic items to check before any work is to begin. If any problems are found during your Pre-oper- ational Check, have them repaired immediately. Never operate a machine that is unsafe, damaged or in need of repair.
PERFORM A WALK AROUND CHECK OF YOUR MACHINE A. Look for any obvious missing or damaged items. B. Check the condition of the loading and backhoe buckets, look for loose or missing attachment pins, damaged surfaces or missing parts. C. Check the condition of all visible hydraulic hoses, look for worn or leaking fittings, cut, scuffed or cracked hose sur- faces. If any hose is found to be worn, cracked or leaking have it repaired or replaced immediately. D. Check for leaking or damaged hydraulic cylinders. If any cylinder is damaged or leaking have it repaired immedi- ately. E. Inspect the mechanical lift, dump and backhoe arms and pivot points.
Look for any loose or missing parts, cracked, bent or damaged areas. F. Be sure all safety decals are in place and are not damaged. Be sure they are clean and visible for all personnel to see. G. Check the condition of the front and rear tires. Look for excess wear or cut surfaces, objects imbedded in the tire or under inflation. H. Check under the machine for any build-up of debris, trash or leaks. Remove any debris that is found and have the leak checked by authorized personnel. I. Inspect the fuel and hydraulic tanks for damage or leaks. Be sure the fill caps are installed and locked in place. J. Be sure the steps are not damaged or covered with mud. K. Check the condition of the cab.
inspect the windows, mirrors, hand holds, work lights, directional and canopy for any damage or missing parts. Be sure all locks are functional. L. Check the exhaust stack, be sure it is not damaged, kinked or restricted in any way. Be sure the exhaust outlet is fac- ing away from the cab and is not restricted. UNDER THE HOOD A. Open the hood and check all fluid levels. be sure they are at the specified level outlined in the maintenance section. B. Check the engine and radiator for any build up of trash, wood chips, rubbish, leaves or other flammable materials.
If flammable materials are found as well as excess build up of oil or dust, remove the flammable material or have the engine cleaned. C. Be sure the hood closes properly and will lock securely to prevent tampering by others. 1-8 WB140-2N, WB150-2N