OPERATION FUSES AND RELAYS FUSE AND RELAY PANEL LOCATION The fuses and relays are grounded on a single base positioned inside the front dashboard below the steering wheel and to the right of the instru- ment bezel. Removing cover (1) exposes the fuses and relays if service should be required. If an electrical system should fail during operation it is important to check the fuses or relays first. Each fuse bank is set-up with a red LED indicator to alert the operator or service personnel of the blown fuse in a particular bank. The relay bank is also set-up with a yellow LED indicator to alert the operator or service personnel of a non-functioning relay.
Once cover (1) is removed the fuses and relays are easily assessable. With the ignition key in the “ON” position look and see which LED is on. This will indicate which bank of fuses or relays have failed. To replace a fuse or relay the ignition switch must be in the “OFF” posi- tion. Remark When replacing fuses or relays always check the condition of the contacts for corrosion. If the panel is badly corroded, con- tact your Komatsu Dealer for repair. Never replace a fuse with a fuse of higher or lower amp rating. Damage to the elec- trical system may result. DASHBOARD RELAY LOCATION The relay positions (1,2 and 3) are located behind the instrument bezel in the dashboard above the fuse panel.
To access these relays, the instrument bezel (11) must be removed to access. WB140-2N, WB150-2N 2-27 Position Description 1. Blower relay (if equipped) 2. Air conditioning relay (if equipped) 3. Return-to-dig relay (front end loader)