Komatsu — STARTING THE ENGINE

OPERATION OPERATING THE MACHINE Before starting your work operations it is important to perform several procedures to be sure your equipment is safe to operate. It is also important to be aware of the hazards involved when operating your machine. Study the section in safety: See “PRE- CAUTIONS BEFORE STARTING WORK OPERATIONS” on page 1-8 before proceeding with any work operations. CHECKING THE FUEL SUPPLY Before starting the machine it is important to be sure there is enough fuel in the fuel tank. To check, turn the ignition key to the “ON” position and read the fuel gauge (1). If fuel is low, add fuel.

Be sure when filling the fuel tank you leave enough space in the tank for the fuel to expand. Never overfill the fuel tank. Do not smoke when refueling and do not use fuel additives or mix gaso- line with diesel fuel. these may damage fuel pump and injector parts. STARTING THE ENGINE Before starting the engine be sure all personnel are clear of your work area or travel path. To start the engine: Be sure the directional control lever (1) is in a neutral ( N ) position. The engine will not start with the directional control lever in a forward or reverse position. Be sure the throttle control lever is set at a low idle speed.

With your foot off the accelerator pedal turn the ignition key to the start position. When the engine starts, release the key, the ignition switch will return to the “ I ” position automatically With the engine now running, check all the gauges and warning indica- tors. Be sure the system is operating normal and you allow the engine and hydraulic system time to warm up before starting work. Remark If the engine does not start within 15 seconds, release the ignition switch and wait for 30 seconds before trying again. If it will not start, do not continue to crank the engine, damage to the starter may result. Contact your Komatsu Dealer for repairs. WB140-2N, WB150-2N 2-31