UNDERCARRIAGE / Upper and Lower Roller Disassemble Lower Roller 5. Remove floating seal (1) from roller (8) and collar (4). IMPORTANT: Put the matching marks on collar (4) and axle (2). 1. Remove plug (6) from the end of collar (4). Drain oil. (2 places). Remove pin (5) from collar (4) (2 places) by using a bar (Dia. 25 mm (1.0 in)) and hammer. : 6 mm 1 4 CAUTION: Lower roller (8) weight: ZAXIS450-3, 450LC-3, 470H-3, 470LCH-3: 80 kg (176 lb) ZAXIS500LC-3, 520LCH-3: 108 kg (238 lb) 2. Set the roller (8) assembly to the press. Push axle (2) until O-ring (3) is removed from collar (4) by using a press. Remove collar (4) from axle (2). W105-03-06-026 6. Set the axle (2) assembly to a press.
Remove axle (2) from collar (4). NOTE: Collar (4) can be removed if axle (2) is pushed in by approx. 55 mm (2.2 in) by using a press. 3. Remove floating seal (1) from collar (4) and roller (8). Remove O-ring (3) from axle (2). CAUTION: Axle (2) weight + collar (4) weight: ZAXIS450-3, 450LC-3, 470H-3, 470LCH-3: 25 kg (55 lb) ZAXIS500LC-3, 520LCH-3: 38 kg (84 lb) 4. Remove the axle (2) assembly from roller (8). W105-03-06-027 7. Remove O-ring (3) from axle (2). 8. When replacing bushing (7), remove bushing (7) by using special tool (ST 1955) and a press. ST 1955 W105-03-06-028 W3-6-9 4 1 8 1 4 2 4 S 7