FRONT ATTACHMENT / Cylinder REMOVE AND INSTALL CYLINDER Preparation 1. Park the machine on a solid, level surface. Fully retract the bucket and arm cylinders and lower the front attachment onto the ground. 2. Stop the engine. Operate the control lever several time with the pilot shut-off lever in the UNLOCK position and release any pressure in the circuit. W1J1-04-01-001 NOTE: The accumulator is equipped for the pilot circuit. After the engine stops, when the control lever is operated several time with the pilot shut-off lever in the UNLOCK position, any pressure can be released in the circuit. 3. Release any pressure in the front attachment pipe.
(Refer to the HYDRAULIC CIRCUIT PRESSURE RELEASE PROCEDURE on W4-1-1.) 4. Release the pressure in the hydraulic oil tank. (Refer to BLEED AIR FROM HYDRAULIC OIL TANK on W1-4-1.) W4-2-1