hitachi — REMOVE AND INSTALL CYLINDER

FRONT ATTACHMENT / Cylinder Removal 1. Remove the lubrication hoses (4 used) from the rod side and bottom side in boom cylinder (6) on both sides. CAUTION: Pin (7) weight: 24 kg (53 lb) 6. Remove bolt (9) from the bottom side of boom cylinder (6). Remove spring washer (10) and washer (8). Pry and remove pin (7) by using a pry bar. Remove boom cylinder (6). Remove spacer (11) and shim (12). (Shim (12) may not be installed.) : 19 mm CAUTION: Boom cylinder weight: 430 kg (950 lb) Pin (1) weight: 90 kg (200 lb) CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 2.

Attach a wire rope onto boom cylinder (6) and hold boom cylinder (6). Remove bolts (5) (4 used) from the cylinder rod side. Remove spring washers (4) (4 used), stopper (3) and washer (2). Remove pin (1) from the cylinder rod hole. Place boom cylinder (6) on a stand. : 30 mm 7. Remove other boom cylinder (6) in the same procedures. : 30 mm 3. Remove other boom cylinder (6) in the same procedures. 4. Start the engine. Retract the cylinder rod to the stroke end. Pass a wire through the cylinder rod hole and secure the rod in order not to extend boom cylinder (6). 5. Stop the engine. Release any remaining pressure in the hydraulic lines and air in oil tank. Remove the hydraulic hoses (4 used).

(Refer to W4-1-1, W1-4-1.) 41 mm W4-2-3