FRONT ATTACHMENT / Cylinder Installation CAUTION: Boom cylinder weight: 430 kg (950 lb) Pin (7) weight: 24 kg (53 lb) CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 7. Hoist the boom cylinder rod side on other side. While adjusting the height, extend the cylinder rod. Align the pin hole on cylinder rod side with that on boom side. Install pin (1) into the hole on the boom cylinder rod side. 8. Install bolts (5) (4 used for each), spring washers (4) (4 used for each), stopper (3) and washer (2) to both sides of pin (1). CAUTION: Metal fragments may fly off when a hammer is used.
Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 1. Hoist boom cylinder (6) and align with the pin hole on cylinder bottom side. Install spacer (11) to inside and install shim (12) to outside. Install pin (7). Install washer (8), spring washer (10) and bolt (9). : 30 mm : 30 mm : 400 N m (41 kgf m, 295 lbf ft) 2. Install other boom cylinder (6) in the same procedures. 3. Install the hydraulic hoses (4 used). Remove the wire to secure the cylinder rod. : 400 N m (41 kgf m, 295 lbf ft) 9. Install the lubrication hoses (2 used). : 29.5 N m (3 kgf m, 22 lbf ft) 10.
When all work is completed, operate the boom cylinder for several times to stroke end and bleed air from the circuit. : 19 mm : 41 mm : 210 N m (21 kgf m, 155 lbf ft) 4. Install the lubrication hoses (2 used) to the bottom side of boom cylinder (6) on both sides. : 19 mm : 29.5 N m (3 kgf m, 22 lbf ft) 5. Hoist the cylinder rod side. While adjusting the height, extend the cylinder rod. Align the pin hole on cylinder rod side with that on boom side. CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 6. Install pin (1) from the cylinder rod side. CAUTION: Pin (1) weight:
90 kg (200 lb) W4-2-5