hitachi — REMOVE AND INSTALL CYLINDER

FRONT ATTACHMENT / Cylinder Removal 1. Remove the lubrication hose from the rod side of arm cylinder (2). CAUTION: Pin weight: 25 kg (55 lb) : 19 mm CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 5. Remove lock nuts (5) (2 used) from the bottom side of arm cylinder (2). Remove bolt (3). Remove pin (1). Hoist and remove arm cylinder (2). CAUTION: Arm cylinder weight: 660 kg (1455 lb) Pin weight: 25 kg (55 lb) CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 2.

Insert the wooden blocks between the boom and arm cylinder (2). Attach a wire rope onto arm cylinder (2) and hold arm cylinder (2). Remove lock nuts (5) (2 used) from the cylinder rod side. Remove bolt (3). Remove pin (1). : 30 mm : 30 mm 3. Start the engine. Retract the cylinder rod to the stroke end. Pass a wire through the cylinder rod hole and secure the rod in order not to extend arm cylinder (2). 4. Stop the engine. Release any remaining pressure in the hydraulic lines and oil tank. Remove the hydraulic hoses (2 used) and the lubrication hose from the bottom side. (Refer to W4-1-1, W1-4-1.) : 12 mm : 19 mm W4-2-7