FRONT ATTACHMENT / Cylinder Installation CAUTION: Arm cylinder weight: 660 kg (1455 lb) 1. Hoist arm cylinder (2). Align the pin hole on the mounting part for cylinder bottom side. CAUTION: Pin weight: 25 kg (55 lb) CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 5. Hoist pin (1). Insert pin (1) into the pin hole on cylinder rod side and install pin (1) to the arm. Install bolt (3) and lock nuts (5) (2 used) to stopper (4) in the arm. CAUTION: Pin weight: 25 kg (55 lb) CAUTION: Metal fragments may fly off when a hammer is used.
Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 2. Hoist pin (1). Insert pin (1) into the pin hole on cylinder bottom side. Align the bolt holes on pin and stopper (4) in boom. Install bolt (3) and lock nuts (5) (2 used) to stopper (4). Insert the wooden blocks between the boom and arm cylinder (2). : 30 mm : 400 N m (41 kgf m, 295 lbf ft) 6. Install the lubrication hose to pin (1) at the rod side of arm cylinder (2). : 19 mm : 29.5 N m (3 kgf m, 22 lbf ft) 7. When completing the work, operate the arm cylinder several times to the stroke end and release the pressure in the circuit. : 400 N m (41 kgf m, 295 lbf ft) 3.
Install the hydraulic hoses (2 used) and the lubrication hose to the bottom side. : 30 mm : 12 mm : 140 N m (14 kgf m, 103 lbf ft) : 19 mm : 29.5 N m (3 kgf m, 22 lbf ft) 4. Hoist the cylinder rod. Remove the wire to secure the rod. Start the engine. Extend the cylinder rod. Align the pin hole on cylinder rod side with that on arm. W4-2-9