hitachi — REMOVE AND INSTALL CYLINDER

FRONT ATTACHMENT / Cylinder Removal 1. Insert a wooden block between the arm and bucket cylinder (4). Remove the lubrication hose from the bottom side of bucket cylinder (4). 1. Remove the hydraulic hoses (2 used) from the cylinder bottom side. : 19 mm 2. Place the wooden block under link A (1). Secure link A and link B by using a wire in order not to drop links B (6) (2 used) when removing pin (5). : 10 mm CAUTION: Pin (8) weight: 20 kg (44 lb) CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 7. Remove lock nuts (2) (2 used) from the cylinder bottom side. Remove bolt (3).

Remove pin (8). CAUTION: Bucket cylinder weight: 410 kg (905 lb) Pin (5) weight: 46 kg (101 lb) CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 3. Attach a wire rope onto bucket cylinder (4) and hold bucket cylinder (4). Remove lock nuts (2) (2 used) from the cylinder rod side. Remove bolt (3). Remove pin (5) and remove shims (7) (2 used). : 30 mm 8. Hoist and remove bucket cylinder (4). : 30 mm 4. Start the engine. Retract the cylinder rod to the stroke end. Pass a wire through the cylinder rod hole and secure the rod in order not to extend bucket cylinder (4). 5. Stop the engine.

Release any remaining pressure in the hydraulic lines and oil tank. (Refer to W4-1-1, W1-4-1.) W4-2-11