FRONT ATTACHMENT / Cylinder Installation CAUTION: Bucket cylinder weight: 410 kg (905 lb) 1. Hoist bucket cylinder (4). Align the pin hole on mounting part for cylinder bottom side with that on arm side. CAUTION: Pin (5) weight: 46 kg (101 lb) CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 5. Hoist pin (5). While aligning, insert pin (5) into the pin hole on cylinder rod side. Install bolt (3) and lock nuts (2) (2 used). Insert shim (7) so that the maximum clearance between link A (1) and link B (6) is 1.5 mm or smaller. CAUTION: Pin (8) weight: 20 kg (44 lb) CAUTION:
Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 2. Hoist and insert pin (8) into the cylinder bottom side. Install bolt (3) and lock nuts (2) (2 used) to stopper (9) in the arm. Insert a wooden block between the arm and bucket cylinder (4). : 30 mm : 400 N m (41 kgf m, 295 lbf ft) 6. Remove the wire to secure links B (6) (2 used) in order not to drop. Start the engine. Remove the wooden block set under link A (1). 7. After completing the work, operate the bucket cylinder several times to the stroke end and release the pressure in the circuit. : 400 N m (41 kgf m, 295 lbf ft) 3.
Install the hydraulic hoses (2 used) and the lubrication hose to the bottom side in bucket cylinder (4). : 30 mm : 10 mm : 90 N m (9.2 kgf m, 66 lbf ft) : 29.5 N m (3 kgf m, 22 lbf ft) 4. Hoist the cylinder rod side. Remove the wire to secure the cylinder rod. Start the engine. Extend the cylinder rod. Align with the pin (5) holes on link A (1) and link B (6). : 19 mm W4-2-13