FRONT ATTACHMENT / Cylinder Disassemble Boom Cylinder The disassembling procedure starts on the premise that the hydraulic lines and the bands securing lines have been removed. 5. Remove set screw (16). : 6 mm NOTE: As set screw (16) was mushroomed by using a punch and hammer at two places after set screw (16) had been screwed in, cut away its mushroomed part by using a drill first. 6. Loosen nut (17) and remove piston (14) by using special tool (ST 5908). Special Tools when turning nut: 125 mm (ST 3268) IMPORTANT: Do not re-use Teflon ring (12) and wear ring (13). When the cylinder disassembled, replace teflon ring (12) and wear ring (13) with the new ones. 7.
Remove seal ring (15), wear rings (13) (2 used) and teflon rings (12) (2 used) from piston (14). 8. Remove cushion ring (11) and cylinder head (9) from cylinder rod (1). 9. Remove O-ring (10) and retaining rings (2, 7) from cylinder head (9). Remove dust seal (3), ring (5), seal (4) and bushing (6). Special tool when removing bushing: 115 mm (ST 2671) CAUTION: Boom cylinder weight: 430 kg (950 lb) 1. Hoist the cylinder. Secure the cylinder on a workbench horizontally. Drain hydraulic oil from the cylinder. W102-04-02-027 2. Fully extend and support cylinder rod (1). Remove socket bolt (8) from cylinder head (9). : 19 mm IMPORTANT:
Pull out cylinder rod (1) straightly in order not to damage the sliding surface. 3. Tap and remove cylinder head (9) with cylinder rod (1) together from cylinder tube (18) by using a plastic hammer. 4. Secure cylinder rod (1) on special tool (ST 5908). Put the matching marks on cylinder rod (1) and nut (17). ST 5908 W158-04-02-022 W4-2-15