FRONT ATTACHMENT / Cylinder Disassemble Arm Cylinder, Bucket Cylinder As the other hydraulic oil cylinders are very similar in construction, the procedures of arm cylinder are shown as an example. The disassembling procedure starts on the premise that the hydraulic lines and the bands securing lines have been removed. IMPORTANT: Pull out cylinder rod (1) straightly in order not to damage the sliding surface. 3. Tap and remove cylinder head (3) with cylinder rod (1) together from cylinder tube (23) by using a plastic hammer. 4. Secure cylinder rod (1) on special tool (ST 5908). Put the matching marks on cylinder rod (1) and nut (22). CAUTION: Cylinder weight: Arm cylinder:
660 kg (1455 lb) Bucket cylinder: 410 kg (905 lb) 1. Hoist the cylinder. Secure the cylinder on a workbench horizontally. Drain hydraulic oil from the cylinder. ST 5908 W158-04-02-022 5. Remove set screw (13). : 8 mm NOTE: As set screw (13) was mushroomed by using a punch and hammer at two places after set screw (13) had been screwed in, cut away its mushroomed part by using a drill first. W102-04-02-027 CAUTION: Cylinder rod (1) weight: Arm cylinder: 275 kg (606 lb) Bucket cylinder: 170 kg (375 lb) 2. Fully extend cylinder rod (1) and hold cylinder rod (1). Remove socket bolts (4) (8 used) from cylinder head (3). Bucket : 19 mm Arm : 22 mm W4-2-19