FRONT ATTACHMENT / Cylinder 6. Loosen nut (21) and remove piston (17) by using special tool (ST 5908). Remove the nut. Remove shim (21) from cylinder rod (1). Special Tool when turning nut: Arm cylinder ST 3283: 135 mm (5.3 in) Bucket cylinder ST 7213: 130 mm (5.1 in) 10. Remove retaining ring (10) and bushing (9) from cylinder head (3). 11. Remove O-ring (12) and backup ring (11) from cylinder head (3). ST 5908 W158-04-02-022 NOTE: Shim (21) is not equipped for the bucket cylinder. IMPORTANT: Do not re-use slide rings (18, 19). When the cylinder disassembled, replace slide rings (18, 19) with the new ones. 7.
Remove slide rings (18) (2 used), (19) (2 used) and seal ring (20) from piston (17). 8. Remove cushion bearing (16), cushion seal (15) and cylinder head (4) from cylinder rod (1). NOTE: Cushion seal (15) is not equipped for the bucket cylinder. IMPORTANT: Do not re-use slide ring (5). When the cylinder disassembled, replace slide ring (5) with the new one. 9. Remove wiper ring (2), slide ring (5), backup ring (6), U-ring (7) and buffer ring (8) from cylinder head (3). W4-2-21