FRONT ATTACHMENT / Cylinder Assemble Boom Cylinder 1. Install bushing (6) to cylinder head (9). Special tool when installing bushing: ST 2671: 115 mm (4.5 in) 2. Install ring (5), seal (4) and retaining ring (7) to cylinder head (9). 3. Install dust seal (3) to cylinder head (9) by using a plastic hammer. Special tool when installing dust seal: ST 2672 4. Install O-ring (10) and retaining ring (2) to cylinder head (9). 5. Install wear rings (13) (2 used), seal ring (15) and teflon rings (12) (2 used) to piston (14). 6. Install the cylinder head (9) assembly to cylinder rod (1). IMPORTANT:
Install cushion ring (11) with part R in cushion seal (11) facing to the nut (17) side in cylinder rod (1). 7. Install cushion ring (11) to cylinder rod (1). Install the piston (14) assembly to cylinder rod (1). 8. Align the matching marks before disassembling and tighten nut (17) by using special tool (ST 5908). Special Tool when turning nut: ST 3268: 125 mm (4.9 in) : 14220 ± 1420 N m (1450 ± 145 kgf m, 10490 ± 1049 lbf ft) ST 5908 W158-04-02-022 9. Tighten nut (17) with set screw (16). Crimp by using a punch at two places. : 6 mm : 64 ± 5.9 N m (6.5 ± 0.6 kgf m, 47 ± 4.4 lbf ft) IMPORTANT:
Align with the center of cylinder tube (18) and insert the cylinder rod (1) assembly straightly in order not to damage the rings. 10. Secure cylinder tube (18) horizontally on a workbench. Insert the cylinder rod (1) assembly into cylinder tube (18). 11. Tighten cylinder head (9) to cylinder tube (18) with socket bolts (8) (8 used). : 19 mm : 1230 ± 123 N m (125 ± 12.5 kgf m, 907 ± 91 lbf ft) W4-2-23