Perkins — To check Operation 4-10

4 400 Series Connecting rod bearing clearance To check Operation 4-10 To check the clearance between the crankshaft bearing journal and the bearing cap. 1 Clean the bearing surfaces and the exposed half of the crankshaft journal. 2 Fit the bearing caps and tighten the bearing cap to torque. 3 Remove the bearing cap of the clearance to be checked. 4 Place a piece of Plastigauge ® across the full width of the bearing surface on the crankshaft journal, fit the bearing cap and tighten the bearing cap setscrew to the specified torque. 5 Remove the bearing cap but do not move the Plastigauge ® . 6 Use the Plastigauge ® envelope to measure the widest point of the Plastigauge ® .

This reading indicates the bearing clearance in thousandths of an inch. 7 If the bearing clearance is not within the specifications the crankshaft must be reground and undersize bearings fitted. Engine Torque Nm (lbf ft) kgf m 403C-11 Bearing carrier setscrew 23 (16.9) 2,3 403C-15, 404C-22 and 404C-22T Bearing carrier setscrew 52 (38.3) 5,2 1.0 PLASTIGAUGE 2.0 2.5 3.0 4.0 5.0 6.0 7.0 INCH H1066 42 Workshop Manual, TPD 1458E, issue 3 - Perkins Confidential:

Green Engine Journals Sta ndard clearance Service limit 1 and 2 0,039 - 0,092 m 403C-11 3 0,029 - 0,082 m m (0.00150 - 0.00360 in) 0,20 mm (0.0079 in) m (0.00110 - 0.00320 in) 0,20 mm (0.0079 in) 403C-15, 404C-22 and 404C-22T All 0,035 - 0,085 m m (0.00138 - 0.00335 in) 0,20 mm (0.0079 in)