Perkins — To remove and to fit Operation 6-11

400 Series 6 Idler hub To remove and to fit Operation 6-11 To remove the lubricating oil pump idler hub the crankshaft must be removed. The oil pump idler hub can then be removed with a suitable drift and hammer from the inside of the engine block. 1 Fit the location pin (1) into the block. 2 Place the idler hub (4) into the idler hub tool (3) and fit on the location pin (1). 3 Using the hammer (2) hit the idler hub tool until the hub is fitted. Caution: Always fit a new idler gear hub, do not fit the old hub, as it may be damaged when removed. 1 2 3 1 4 H1078 Workshop Manual, TPD 1458E, issue 3 - Perkins Confidential:

Green 61 Engine Special tools Description Part nu 403C-11 Idle r hub fitting tool 2182 403C-15 404C-22 Idle 404C-22T r hub fitting tool 2182