400 Series 9 Turbocharger To remove and to fit Operation 9-3 Engine Torque Nm (lbf ft) kgf m Turbocharger to manifold nuts 25 (18.4) 2.5 Elbow securing set screws 32,4 (23.9) 3,3 Oil feed pipe banjo bolt to turbocharger 20 (14.8) 2,0 404C-22T Oil drain pipe set screws 10 (7.3) 1,0 Oil feed pipe set screws to cylinder block The turbocharger is fitted only to the 404C-22T engine. Caution: The bearing housing of the turbocharger must be lubricated with clean engine oil on assembly. Note: There is an ‘O’ ring fitted between the oil feed pipe for the turbocharger and the cylinder block. Workshop Manual, TPD 1458E, issue 3 - Perkins Confidential: Green 75 H1120 1120