PACCAR PX-9 — Warranty and the Use of Biodiesel Fuel

ENGINE MAINTENANCE - Warranty and the Use of Biodiesel Fuel CAUTION that are operated at temperatures above 32єF (0єC). Warranty and the Use of Biodiesel Fuel If ultra-low-sulfur diesel (ULSD) fuel is not used, the engine may not meet emission regulations, and damage may occur to the exhaust aftertreat- ment system. The use of high-sulfur diesel fuel will damage the exhaust af- tertreatment system and impact the engine emission. ULSD fuel is re- quired for correct operation of the af- tertreatment. The engine has been op- timized for use with an aftertreatment system together with ULSD fuel to meet the 2013 U.S. Environmental Protection Agency regulations.

Failure to comply may result in equipment or property damage. Using diesel fuel with a lower-than- recommended cetane number can cause hard starting instability, and excessive white smoke. To maintain satisfactory operation at low ambient temperatures, it is important to specify diesel fuel of the correct cetane number. 2 Biodiesel information and warranty precautions. PACCAR Inc. approves the use of biodiesel fuel blends up to 20 percent by volume in diesel fuel providing that the following conditions are met: PACCAR requires all permissible fuels to have adequate fuel lubricity.

Lubricity can be determined by ASTM, specification D6079, ISO 12156, High Frequency Reciprocating Rig (HFRR) in which the fuel must have a wear scar diameter of 0.02 in. (0.5 mm) or less. The biodiesel used in the blend meets ASTM Standard D6751 or EN 14214 specifications. The biodiesel used in the blend is sourced from a BQ-9000 Accredited Producer. The finished blend meets the fuel properties of the ASTM Standard D975 (up to B5 blend) or D7467 (B6 to B20 blend). If using B6-B20 the engine oil and oil filter are changed per the modified schedule. See the Engine Preventative Maintenance Schedule. If using B6-B20 the fuel filter is changed every 25,000 miles (40,000 km).

The use of Ultra-low-sulfer diesel (ULSD) fuel is required for this engine in order to meet emission regulations and to prevent damage to the engine and exhaust system. The use of other grades of diesel fuels other than ULSD fuel will be considered a use of incorrect fuel for the engine. PACCAR is not responsible for failures caused by the use of incorrect fuel, oil or DEF or by water, dirt or other containments in the fuel or DEF. NOTE PACCAR recommends that the cetane number of diesel fuel be a minimum of 45 for engines that are expected to op- erate at temperatures below 32єF (0єC) and a minimum of 42 for engines Y53-1185-1E1 (04/16/18) 53