PACCAR PX-9 — After Replacing Engine Oil Filter(s)

ENGINE MAINTENANCE - Maintenance Procedures Oil Filter Removal Preparation After Replacing Engine Oil Filter(s) This procedure should be followed before replacing engine oil filters. battery clamp and the negative termi- nal before working on the vehicle. Working on a vehicle while the battery is connected may result in electrical in- jury or damage. Always disconnect the battery at the negative terminal when performing service procedures. Failure to comply may result in death, person- al injury or equipment damage. Procedure for what to do after installing new oil filters. 2 Follow the steps below after installing new oil filters:

CAUTION Before beginning to remove and/or disconnect any components, wait at least 5 minutes after the key switch is turned OFF for the aftertreatment DEF dosing system to purge the DEF from the system. The DEF system purges to prevent damage from freezing. Fail- ure to comply may result in equipment or property damage. 1. Reconnect the chassis battery cable at the negative battery terminal. See "Oil Filter Removal Preparation." 2. Add SAE-approved CK-4/CJ-4 engine oil to the maximum level marked on the dipstick. If the engine is running a different weight of oil, be sure to top-off the engine oil with the same brand and viscosity of oil. 3.

Start and run the engine for 5 to 10 minutes and check for any oil leaks. 4. Remove oil collection pan and dispose of any spillage properly. 5. Shut down the engine, check the oil level and top up as necessary. See "Engine Oil Level." WARNING Electrical shock hazard: Never discon- nect the battery clamp when the en- gine is running. Disconnecting the bat- tery clamps while the engine is running may result in death, personal injury or equipment damage from electrical arc- ing or damage to electrical compo- nents. WARNING Turn off the engine and place the igni- tion switch in the OFF position before disconnecting the battery clamps.

DO NOT place any tools or other materials on top of or close to the batteries. This can cause a dangerous high current short circuit and, in the worst case, a battery explosion. Keep all objects away from the battery terminals. Al- ways break the contact between the 1. Disconnect the chassis battery cable at the negative battery terminal. 2. Place an oil collection pan directly under the oil filter. 58 Y53-1185-1E1 (04/16/18)