. OPERATION DETAILED CONTROLS AND GAUGES FUSIBLE LINK Fusible link (2) is taped to the nearby wiring carrying out inspection or replacement, check number. high current flow portion of the circuit to protect CONTROLLER Controller installed. Open the front engine hood.It is under the fuel pre-filter. 3 - 109 If t he st arting motor does no t turn when the starting switch is turned to the S TART position, ther e is probably a disconnection in fusible link (1) or (2). Open the ba ttery box cover on the right side of the chassis , then check and re place the fusible link (1): Fu sible link for 24 V po (2): Fu sible link for starting arness.
When he arness REMAR A fusib installed electric al components and wiring from burning, in the sam e way NOTICE reful not to get water, mud, or juice on the controller. This will cause failure. Be ca reful not to get water, mud, or juice on the controller . This will ca The e ngine controller has b een given moisture prevention treatment, s o there is no problem if rai n gets on it, but do not spray it wit h water when washing the machine. the controller, do not disassemble it yourself. Contact your Komatsu distributor for repairs. If any abnormality occurs in the controller, do not disassemble it yourself.
Contact your Komats Engi ne controller Pum This is on the right side a t the rear of the operator's seat