. OPERATION MACHINE OPERATIONS AND CONTROLS Check for Water and Sediment in Water Separator, Drain Water 1. Open the cover on the right side of the machine. monitor, it indicates that water is accumulated in transparent cap (2). In this case also, use the procedure above to drain the water. REMARK REMARK If transparent cap (2) is dirty or it is difficult to see the inside, clean transparent cap (2) when replacing fuel pre-filter cartridge (1). When the drain valve (4) has been removed during the cleaning operation, coat the O-ring with grease and tighten until it contacts the bottom. 3 - 114 orms one unit with fuel pre-filter ( 1). 2. It is possible to judge th is any water or sedimen 3.
Loosen drain valve (4) a 4. When fuel starts to drai e water level and amount of sediment by looking through transp arent cap (2). If there t collected at the bottom, set a container to catch the drain water under drain hose (3). n from drain hose (3), tighten drai On this machine, a sens accumulated in transparent When the water separator m When only the water separa tor monitor lights up, it lights up in position shown in the diagra If other monitors also light u monitor lights up at a differe NOTICE If the water accumulated in transparent cap (2) freezes, the water separator monitor may not light up. After the engine is up.
After the engine is started, as the temperature a suddenly light up. In cold ar round fuel pre-filter (1) increases, the frozen water will melt and the wate r separator monitor may eas, even if the water separator monitor does not light up, drain the wat er frequently. If the water inside transparen t cap (2) freezes, check that the frozen water has melted completely, then use the procedure above to drain the water.