. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE water temperature has gone down cap (2) slowly until it contacts the 4. Following this, push radiator cap (2), turn it until it contacts the stopper, then remove it. solution, close drain valve (4), the radiator is filled with water, at low idle speed. After the water 90 ° C (194 ° F), run the engine for 4 - 27 3. enough to make it possible hand, then turn radiator c stopper to release the pres Following this, push radiat 5. Remove the cover (3), then (4) to catch the coolant mi Open drain valve (4) at the coolant. After draining the antifree then fill with clean water. A start and run the engine temperature rises above 6.
7. 8. about 10 minutes. Stop the engine and open After draining the water, cl For the cleaning method, f 9. Close drain valve (4). Install the cover (3). 10. 11. Replace the corrosion resi stor, then turn the valve (1) fully to the left to open it. (Only machines equipped with corrosion resistor) t of the corrosion resistor cartridge, see "REPLACE CORROSION RESISTOR )". tifreeze until it overflows from the water filler. For details of replacemen CARTRIDGE (PAGE 4-72 12. Add coolant mixed with an Decide the proportions of a ntifreeze and water according to the table for the mixing rat e of water and antifreeze. 13.
Run the engine at low idlin g for 5 minutes to remove the air from the water, then run at high idling for 5 minutes. (Leave radiator cap (2) rem oved when doing this.)